Introduction¶
CircuitPython library for the PMW3360 motion sensor. Port of Arduino PMW3360 Module Library by SunjunKim.
Tested working on KB2040 (RP2040), Adafruit Feather M4 Express (SAMD51) and Adafruit ESP32-S3 Feather with 4MB Flash 2MB PSRAM (ESP32-S3).
Dependencies¶
This driver depends on:
Please ensure all dependencies are available on the CircuitPython filesystem. This is easily achieved by downloading the Adafruit library and driver bundle or individual libraries can be installed using circup.
Installing to a Connected CircuitPython Device with Circup¶
Make sure that you have circup
installed in your Python environment.
Install it with the following command if necessary:
pip3 install circup
With circup
installed and your CircuitPython device connected use the
following command to install:
circup install pmw3360
Or the following command to update an existing version:
circup update
Usage Example¶
import PMW3360
import board
from digitalio import DigitalInOut, Direction
# board.SCK may be board.CLK depending on the board
# board.D10 is the cs pin
sensor = PMW3360.PMW3360(board.SCK, board.MOSI, board.MISO, board.D10)
# Any pin. Goes LOW if motion is detected. More reliable.
mt_pin = DigitalInOut(board.A0)
mt_pin.direction = Direction.INPUT
# Initalizes the sensor
if sensor.begin():
print("sensor ready")
else:
print("firmware upload failed")
# Setting and getting CPI values. Default is 800.
sensor.set_CPI(1200)
print(sensor.get_CPI())
while True:
# Captures a snapshot
data = sensor.read_burst()
# uncomment if mt_pin isn't used
# if data["is_on_surface"] == True and data["is_motion"] == True:
if mt_pin.value == 0:
print(data)
Documentation¶
API documentation for this library can be found on Read the Docs.
For information on building library documentation, please check out this guide.
Contributing¶
Contributions are welcome! Please read our Code of Conduct before contributing to help this project stay welcoming.